Banjo Hangout Logo
Banjo Hangout Logo

Premier Sponsors


Nov 18, 2026 - 5:28:28 AM
likes this
6012 posts since 9/12/2016

I have been shimming this with a piece of veneer for a few years now --But to use standard size bridges it is too thick-and I hate distorting it with the coordinator rods-, -with out it --then the action is too low --the veneer btw is about 1/64 inch-so I need to either resand the heel cut's angle or thin down the veneer -I am thinking I will need to pull the dowel screws out and use sandpaper -maybe a drum on a dremel tool --but something less than a 64th is usually way beyond my abilities--any suggestions would be welcome

Nov 18, 2026 - 6:39:06 AM
like this

774 posts since 4/27/2008

Leave the dremel stored away. Cut a sanding block the same radius as your tension hoop. I used a piece of plywood and made a pie shape and used an old broken 1" sanding belt around the radius. Go slow and keep the radius in constant contact with the heel cut. This is the way I cleaned up the ill fitting heel cut on my r35.

Nov 18, 2026 - 7:21:14 AM
likes this

Alex Z

USA

6290 posts since 12/7/2006

"the veneer btw is about 1/64 inch"

"something less than a 64th is usually way beyond my abilities"

1/64 = .016" .  A little sandpaper and 5 minutes can easily get that down to the .008-.010 range.  (Much below that, wood veneer acts like a piece of paper for a shim, and the tone suffers.)  

Compare that to resanding the heel's cut angle to get the precise action height you want, or to the plywood, pie, sanding belt  method, and reassess what is within your abilities.  smiley

Other alternative is to get an inexpensive set of metal feeler gauges, and then can use exactly the thickness you want for a shim, from about .004" for the smallest, on up.

Nov 18, 2026 - 7:45:58 AM

6012 posts since 9/12/2016

I had a failure with a metal shim once --but it was probably preformed poorly--anyway I have a flat head to pull me thru the hospitalization of the arch top

Nov 18, 2026 - 4:50:50 PM
likes this

49 posts since 6/8/2015

Tractor1, Where are you located? If you are near Nashville I have a good recommendation for somebody who could fix you up!

Nov 18, 2026 - 6:42:06 PM

6012 posts since 9/12/2016

Thanks Mike--I am in Louisville kinda--But I already got it fixed-

Nov 19, 2026 - 12:29:19 PM

banjonz

New Zealand

13024 posts since 6/29/2003

quote:
Originally posted by Tractor1

Thanks Mike--I am in Louisville kinda--But I already got it fixed-


What was your fix?

Nov 19, 2026 - 2:05:28 PM
likes this

6012 posts since 9/12/2016

I sanded the veneer down as Alex sugggested

Terms of Use | Privacy Policy | Privacy Consent (EU/GDPR Only)

Copyright 2026 Banjo Hangout. All Rights Reserved.





Hangout Network Help

View All Topics  |  View Categories

0.4882813