Banjo Hangout Logo
Banjo Hangout Logo

Premier Sponsors


Oct 19, 2026 - 8:42:56 AM

Bildad

USA

1 posts since 10/19/2026

You know you've been around a while when you begin restoring an instrument you made in the 20th century. In 1999 I built a mountain banjo in the style of Frank Proffit, who lived two counties away in Watauga County, N.C. This banjo has a a six-inch, goatskin head and a stovepipe tone ring. In 1999 the head shrank into place perfectly taut after tacking the softened hide to the inside of the pot with a temporary spacer (a wooden disk flat on the bench with the head draped over to create the correct amount of slack), then inserting the rustic tone ring and screwing on the back. Eventually the head tore, and I'm replacing it. My question is: what should the dimensions of the disk be. In my memory the disk was 3/4" thick and 2-2.5" in diameter, but I'm not sure. Back in '99 I found the plans (with the disk dimensions) in a Dennis Waring book, but I can't seem to find that book or stovepipe-style plan. Any thoughts?

The next day:  I figured it out, but only after it was too late.  Using the lid from a quart mayonaisse jar as a spacer, I soaked the head for 20 minutes, centered it over the spacer and banjo, and awkwardly tacked it in to place, then realizing that I'd missed a crucial fitting step: inserting the tone ring to temporarily tension the skin over the jar lid and into the rim; marking the jagged line where the skin meets the back edge of the tone ring; removing the tone ring to allow tacking.  Oh well, if I decide to make a second attempt at installing a functional head, I'll know how to do it.

Edited by - Bildad on 10/20/2026 11:28:37

Terms of Use | Privacy Policy | Privacy Consent (EU/GDPR Only)

Copyright 2026 Banjo Hangout. All Rights Reserved.





0.140625