|
rudy |
This method can be used to install any tuner of any type without damage to front veneer or the rear surface. Drill a small dimple where the tuner will go, hold the guide and bit tip against the dimple, and clamp the wooden drill bit guide and backing board in place. Pull the bit out and check centering before actually drilling the hole. This particular hole is 9/32" for violin tuners, but larger holes for nut mounted conventional tuners can be installed in the same manner.
Be the first to comment on “Fitting Pegs”
You must sign into your myHangout account before you can post comments.
Copyright Notice:
The Banjo Hangout myHangout photo albums were created to allow members to post photos which 1) they own the copyrights to, or 2) which are non-copyrighted. Please respect others by not posting their copyrighted images. Photos posted in violation of this notice may be removed by the webmaster without prior notice, and may result in a locking of your myHangout account. Read complete copyright policy.
Terms of Use | Privacy Policy | Privacy Consent (EU/GDPR Only)
Copyright 2026 Banjo Hangout. All Rights Reserved.
