|
rudy |
Neck shaped in four basic steps using Microplane and sanding regimin. 1, initial waste material removed from the neck sides with a 30 degree band saw cut. 2, 45 degree angle to blend top to within 1/8" of center. 3, refine facets into curve from one edge of the fret board to the other side. Refine further by sanding with 60 grit 8" long board to remove humps and irregularities. 4, sand to refine final contours.
Be the first to comment on “Neck Shaping”
You must sign into your myHangout account before you can post comments.
Copyright Notice:
The Banjo Hangout myHangout photo albums were created to allow members to post photos which 1) they own the copyrights to, or 2) which are non-copyrighted. Please respect others by not posting their copyrighted images. Photos posted in violation of this notice may be removed by the webmaster without prior notice, and may result in a locking of your myHangout account. Read complete copyright policy.
Terms of Use | Privacy Policy | Privacy Consent (EU/GDPR Only)
Copyright 2026 Banjo Hangout. All Rights Reserved.
