|
mike gregory |
Rather than shop around for three replacement lugs and four screws for this relatively inexpensive VENTURA banjo, I made 4 blocks, drilled them, glued them in place, ground the side off a Tee nut so it would fit against the resonator wall, and used standard hardware store cap screws to hold the resonator in place. A padded clamp held theblock against the wall, while I used the screw and a washer, to pull the teenut prongs into the wood, from below.
Be the first to comment on “TEE nuts as Resonator lugs.”
You must sign into your myHangout account before you can post comments.
Copyright Notice:
The Banjo Hangout myHangout photo albums were created to allow members to post photos which 1) they own the copyrights to, or 2) which are non-copyrighted. Please respect others by not posting their copyrighted images. Photos posted in violation of this notice may be removed by the webmaster without prior notice, and may result in a locking of your myHangout account. Read complete copyright policy.
