Banjo Hangout Logo
Banjo Hangout Logo

Premier Sponsors

309
Banjo Lovers Online


 All Forums
 Other Banjo-Related Topics
 Banjo Building, Setup, and Repair
 ARCHIVED TOPIC: Binding edge curvature?


Please note this is an archived topic, so it is locked and unable to be replied to. You may, however, start a new topic and refer to this topic with a link: http://www.banjohangout.org/archive/385888

Waltraud - Posted - 09/24/2022:  15:18:19


I'm scraping binding on an old Gibson resonator that had lost much of its old cracked binding. Before finishing I wanted to find out whether the edges of the binding at the top, flange side and bottom or rear / back of the reso should be scraped and sanded to an angle or even a curve or should the top edge be flat- I'm guessing so and the back edge have a similar angle to the top of the binding as the curvature of the resonator back itself? It's a 28 tb2 resonator with two binding channels, the upper one being additional to my taste. As the resonator was in bad shape and needed a new veneer it's far from original. Thanks for looking.

Tim


Edited by - Waltraud on 09/24/2022 15:20:14

rcc56 - Posted - 09/24/2022:  16:13:18


It's been a while since I've had an old Gibson banjo in my lap, but yes, I would at least blunt the sharp corner so it doesn't hurt your arm or leg.  If it were me, I would probably round it a little for comfort's sake.



Since it's no longer in original condition anyway, a minor liberty probably won't hurt the value, as long as the work is well done.



For the record, their guitars from the same period have a beveled top edge on the binding, with the sharp corner knocked off.


Edited by - rcc56 on 09/24/2022 16:16:45

Old Hickory - Posted - 09/24/2022:  16:34:40


The edges are relieved a little. How much, I don't know.



The way I did it on the grand total of two resonators I finished was to roll a small piece of #320 or #400 sandpaper into a tube and go around the edge very lightly two or three times. Just enough to knock off the right angle. I'm pretty sure I read to do that somewhere. Not the type of thing I'd think up on my own.



I believe the edges of the peghead are also typically relieved or softened.

desert rose - Posted - 09/24/2022:  18:45:52


Answer is yes without question the edges are rolled, if you dont when you rfinish you will lern why its always done

Waltraud - Posted - 09/24/2022:  23:45:36


Thank you Scott & guys, seemed most likely but best to check before regretting doing it another way. I'm using your finishing guide Scott which has a really clear sequence and explanation. Thank you for sharing this with our community.

Tim

Terms of Use | Privacy Policy | Privacy Consent
Copyright 2024 Banjo Hangout. All Rights Reserved.





Hangout Network Help

View All Topics  |  View Categories

0.0625